Argent Data Systems OpenTracker USB Instrukcja Użytkownika Pobierz pdf (Strona 12)

Tracker3 User’s Manual 10

7. Jumper Settings

A jumper block on the OT3m board provides the following settings:

Voltage select – ‘5’. Connects pin 4 of the serial connector to the

output of the 5-volt regulator. Use this setting to supply power to

a 5-volt GPS receiver or other external device.

Voltage select – ‘12’. Connects pin 4 of the serial connector to the

input of the 5-volt regulator. Use this setting to supply

unregulated power from the radio connector to a GPS receiver, or

to supply power to the tracker from the serial connector.

‘HI’ – This jumper sets the audio output level to the high range.

This is needed mostly for mobile radios, especially some

commercial models.

‘HT’ – Selects if push-to-talk signaling through the audio output

line is enabled. Use this jumper with most HTs by Icom, Yaesu,

and Alinco handhelds, but not Kenwood.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 54 55

Brak uwag

Argent Data Systems OpenTracker USB Instrukcja Użytkownika Strona 12